This item is based on the DSP-controlled three-phase stepper motor driver. It is combined with advanced DSP control chip and three-phase inverter drive module together constitute the new generation of digital stepping motor driver. Drive voltage is AC110V-220V, Adapter current below 5.8A (7.0A), OD 57-130mm various types of three-phase hybrid stepper motor. This circuit allows the motor running smooth, almost no vibration and noise at high speed, the motor torque is much higher than the two-phase and five-phase hybrid stepping motor. Positioning accuracy is up to 60,000 steps / rev. The products are widely used in the engraving machine, medium-sized CNC machine tools, computer embroidery machine, packaging machinery and other high-resolution large and medium-sized CNC equipment.

Feature

* High performance, low price

* 16 channels angle constant torque subdivision, a maximum resolution of 60,000 steps / rev

* Maximum response frequency is up to 200Kpps

* The pulse stops over 1.5s, the coil current is automatically reduced to half of the set current

* Opto isolated input / output

* Drive current  from 1.2A / to phase 5.8A / phase (1.3A / phase to 7.0A / phase) sub-16 adjustable

* Single power input, voltage range: AC110V-220V

* Phase memory function (Note: the input is stopped for more than 3 seconds, the automatic memory of the drive when the motor phase, re-power or MF signal from low to high, the drive motor automatic recovery phase).

Alternative product item: DVS DV3522(DV3722)    YAKO  YKC3722MA

Current setting

The drive current is set by the D1-D4 terminal, The running current work properly output current setting switch (see table below) 

D9=ON:DR=BRAKE    

D9=OFF:DR=DIRECT

D10=ON:TEST MOTOR AND FUN 

D10=OFF: NORMAL WORK

LIGHT STATE:L1L2 TURN ON:BOTH LIGHT SHINING

L1 ON L2 OFF:WHEN GET THE CP SIGNAL L2 OFF

L2:MOTOR FLIP

L1 ON AND THEN OFF:DRIVER GET THE PU SIGNAL

L1 AND L2 OFF:VOLTAGE IS LOWING

L1 OFF L2 ON:CURRENT TOO HIGH OR MOTOR IS BROKEN.

L1 FLASH L2 ON:VOLTAGE IS TOO HIGH

L1 L2 ALTERNATING BRIGHT:STEPPING MOTOR LEAD LINE

IS NOT CONNECTED OR DRIVER GET TOO HOT AND FUN TURN

BAD. 

Sub-set

Drive segment set by the D5-D8 terminal, a total of 16 stalls, D9 and D10 to the function setting. Schedule: the number of segments (pulse / rev)